Testing Your Home For Mold

Testing for mold in your home is not really a complicated process, but if you should know that if you do not follow the instructions that come on the package to the letter, the test will be almost completely useless both to you and to the mold laboratory that you send the test kit samples to. Most test kits are fairly straight forward, but this is a rundown of what you are going to have to do, even if you do not use just the test kits.

Sometimes knowing where you need to test for mold contamination is pretty easily simply because of the fact that the mold is either completely visible on the walls, ceiling, or other belongings, but also due to the fact that many kinds of mold have a significant musty odor to them. You can take a sample of the mold that you can see on the walls by taking a knife (a clean one) and scraping some of it off into the test kit. Be careful here and do not inhale the mold spores. Wear rubber gloves and a respirator while doing this, if you can. Whether you are wearing gloves or not, though, you should wash your hands afterward before going to test another site and especially before you eat anything.

If you want to, you can also take a piece of scotch tape and lift some of the mold off the wall. Some people may prefer this over the knife method, but it is a matter of personal preference. The knife method is more likely to stir up the spores than the tape method.

Set a test kit out in every room of your home after you have run the air conditioner or fans in every room for about ten to fifteen minutes to get the spores stirred up. Tape at least one kit to the grill of an air conditioning vent so you will know if there is any mold growing inside the duct itself. If the air conditioner continues to blow mold spores out into the house after it has been run for about 15 minutes, you know you have a problem in your ventilation system.

After you collect the test kits from around your house, you need to label them all with your name, address, where each test kit was used in the home, and any other pertinent information. This should also include how long you left the test kit setting out in your home, whether it was 30 minutes or a day.


Jim Corkern is a writer and promoter of quality
Mold Remediation and
water damage restoration companies across the united states.